- Joined
- Sep 14, 2008
- Messages
- 24,836
- Reaction score
- 6,076
- Points
- 113
- Location
- Wibbleton
- Website
- www.tuffty.co.uk
Hmmmm, yum yum....food for thought
Why do you have to use the S4 maf housing, couldnt you use a 4" tube, cut and shape it to your needs and fit the MAF directly to the tube. It would reduce the need to silicone joiners
I think you also need to add an index to your build, the 1st post should have a link to all the specific topics - OK OK, I know I'm being lazy but its takes so long to find things on your build. I have actually book marked a lot of your pages to use as references
4" MAF tube is too large for my setup and have used this setup before on a race car before... idle was a bit rubbish due to large tube and no mesh for laminar flow... not any good for a car used mainly on the road...
Getting the scaling right on it would take a bit of effort (as it did on the LCR) so why bother with the hassle...
<tuffty/>