AllyMc
Registered User
What a superb thread....You make it seem so easier yet I remember all the swear words I learned whilst just changing the rear discs and pads.
Why does everyone worry about the pinch bolts haha
exactly mate. and to use the proper tools. been a really busy week mate with peoples repairs. and remapsBecause people use the wrong techniques
It needs to be turned and pushed at the same time. Instead of just pushed.
(Let me know when ya arnt too busy mate and il pop up)
Christ! You on vvoc?
Really enjoyed reading the thread fantastic work and lovely pictures but a small question for you super Ron I have the same 3.0 litre engine as you, do you know much about the pre-cats on the exhaust, it has been rumoured that the pre-cats waste a lot of power from the engine by limiting the through put of exhaust gases, and I was told there is a lamda sensor each side of the pre-cat does this make pre-cat removal impossible or just very difficult
thanks in advance for any help on this
What's your over all measurements after the springs?
In inches?
I have 19s and mines too low
Yours still looks practical
Can u measure from floor to the middle of the arch please
(Incase people did it different ways lol)
Too work mate, lovely looking car. Especially the white, I always thought they looked cheap but I was wrong
looks very nice stance pal, i painted my 19 rs4 reps a similar colour too, wait till you get the front bumper it will make it look so much tougher up front, i used to have that bumper on mine but got an sline lower and made it fit the upper.
that other audi a4 you was breaking,do you still have it and what are the front wings like? im after a set in silver for my a4!
Awesome stuff m8
Great log.
How were the pinch bolts when you done the front springs?
See your in Ipswich, Im in Bury St Eds so will look out for you ragging it up and down the A14!!!
Great thread just a shame you couldn't go into more detail! LOL
Bet your glad you didn't give up on the first car its a credit to you.
Don't recognise your car bud. Been on there since about 2004 now.Yes i am on vvoc and the vaux forums as rc
Is that a sulfok punch mower if so I just scraped one last year that had the chain cover that you are missing! Dam!
Don't recognise your car bud. Been on there since about 2004 now.
heck, my latest winter project has been my 1960s lawn mower, it only needed roller bearings and ended up with a bare metal respray lmao
Nice mate and I see your in Felixstowe. Let me know if you wanna sell the 18" rs4 alloys.
slightly off topic but why the hell would you want a say old K reg engine in a 2007 corsa in beyond me