Hi Folks,
I recently purchased a 'pre-owned' Autodab unit for my A3 (which has the RNSE head unit installed) and connected it up over the weekend.
The Autodab unit appears to be working, as it responds to the MFSW buttons and I can listen to numerous radio channels........All good!
However, that's about as good as it gets........as the display on the RNSE and the DIS initially only showed the pre-tuned FM station of 87.MHZ, I could scroll through the station list, but I have no idea as to which station I'm actually listening to.
I have tired numerous factory resets etc, with no effect.
And then tonight, its decides to show BBCR6M station on the display and now that's all it displays even after changing the channel and turning the Autodab on & off several times.
Has anyone else encountered these problems with Autodab / RNSE set up...?
I have also previously converted the antenna upper and lower amp swap out to correct the diversity issue....Could this be the course?
I have contacted support at Connects2 but as yet no response.
Any helpful comments or advice would be gratefully accepted.
Thank you,
I recently purchased a 'pre-owned' Autodab unit for my A3 (which has the RNSE head unit installed) and connected it up over the weekend.
The Autodab unit appears to be working, as it responds to the MFSW buttons and I can listen to numerous radio channels........All good!
However, that's about as good as it gets........as the display on the RNSE and the DIS initially only showed the pre-tuned FM station of 87.MHZ, I could scroll through the station list, but I have no idea as to which station I'm actually listening to.
I have tired numerous factory resets etc, with no effect.
And then tonight, its decides to show BBCR6M station on the display and now that's all it displays even after changing the channel and turning the Autodab on & off several times.
Has anyone else encountered these problems with Autodab / RNSE set up...?
I have also previously converted the antenna upper and lower amp swap out to correct the diversity issue....Could this be the course?
I have contacted support at Connects2 but as yet no response.
Any helpful comments or advice would be gratefully accepted.
Thank you,