absolutes3
Registered User
Hi, Asking questions again. I must be hated by now Anyway this is a bit more important this time, A few weeks ago the wife hit a pot hole about 50mph resulting in putting a hole in the tyre. The car has sat in the garage whilst waiting for wheels to be refurbed, New tyres and rear discs and pads.
Tonight me and my mate (both not mecanics) tryed to change all the new bits over, First side fine. Went to the other side took the wheel off and notice the disc and surrounding bit is bent in at an angle. Front of disc pointing a little towards the inside of the car.
We have measured everything and it is out a little but cant be certain what the problem is but there is the smallest of kinks on the lower radius arm. Is this possible? Are these not solid and impossible to bend? Has anyone else had a problem like this or suggest whatelse it might be? More importantly is this gonna be expensive?
Any advice please?
Tonight me and my mate (both not mecanics) tryed to change all the new bits over, First side fine. Went to the other side took the wheel off and notice the disc and surrounding bit is bent in at an angle. Front of disc pointing a little towards the inside of the car.
We have measured everything and it is out a little but cant be certain what the problem is but there is the smallest of kinks on the lower radius arm. Is this possible? Are these not solid and impossible to bend? Has anyone else had a problem like this or suggest whatelse it might be? More importantly is this gonna be expensive?
Any advice please?
Last edited: