Hi,
Wondering if anyone has access to VCDS in Leics area - need help with deciphering / resetting fault code on my car - have posted the code issue before but without any success.
The code appeared after all the (multitronic) gearbox digits in the dashboard started flashing. Car drives normally. Also had trnsmission fluid changed by dealers recently, again they gave the transmission and car a clean bill of health.
Using a basic diagnostic tool so unable to retrieve any more data or clear and reset. Any help greatly appreciated.
The code is - 01119 (under ABS) & 01798 (under Auto Trans) with following explanation on Ross website, so suspect its either ABS sensor or loose connection. Just need a definitive answer and be able to pinpoint the fault.
Code 01119
Signal for speed detection
and Gear Recognition Signal
Additional info on the error codes. intermittent
Possible symptoms:
ABS light is on
Possible causes:
Wiring and / or connections faulty
Possible solutions:
Check / repair wiring and connections
Additional info:
When found in Brake Electronics, check the Transmission Control Module (TCM) for errors.
Following code also appears under auto transmission:
Error Code: 01798
com switch for interior lock (E286), rear center, lock
Switch for interior locking rear center (E286), LOCK
and Rear / Center Central Locking Switch (E286), LOCK
Additional info on the error codes. intermittent
Possible symptoms:
unknown
Possible causes:
Wiring and / or connections faulty
E286 defect
Possible solutions:
Check / repair wiring and connections
Check (measured value blocks) / replace E286
Wondering if anyone has access to VCDS in Leics area - need help with deciphering / resetting fault code on my car - have posted the code issue before but without any success.
The code appeared after all the (multitronic) gearbox digits in the dashboard started flashing. Car drives normally. Also had trnsmission fluid changed by dealers recently, again they gave the transmission and car a clean bill of health.
Using a basic diagnostic tool so unable to retrieve any more data or clear and reset. Any help greatly appreciated.
The code is - 01119 (under ABS) & 01798 (under Auto Trans) with following explanation on Ross website, so suspect its either ABS sensor or loose connection. Just need a definitive answer and be able to pinpoint the fault.
Code 01119
Signal for speed detection
and Gear Recognition Signal
Additional info on the error codes. intermittent
Possible symptoms:
ABS light is on
Possible causes:
Wiring and / or connections faulty
Possible solutions:
Check / repair wiring and connections
Additional info:
When found in Brake Electronics, check the Transmission Control Module (TCM) for errors.
Following code also appears under auto transmission:
Error Code: 01798
com switch for interior lock (E286), rear center, lock
Switch for interior locking rear center (E286), LOCK
and Rear / Center Central Locking Switch (E286), LOCK
Additional info on the error codes. intermittent
Possible symptoms:
unknown
Possible causes:
Wiring and / or connections faulty
E286 defect
Possible solutions:
Check / repair wiring and connections
Check (measured value blocks) / replace E286
Last edited: