lowering

all the lowering kits i can find are for the sportbacks. i have a standard 1.6 (AP1) 3dr 2009 reg. not sport. not anything fancy. i want to lower the car by 50mm. ] HAS anyone lowered an AP1? can i use for example these...

Hi all, I've got a 1.8tfsi s-line which I've recently put 19"s 8.5j on. I'm looking for coilovers for her but not sure what to get. Wanted to get some ideas and advice if possible. Not looking to slam it but get the wheel closer to the arch, so possibly a 30/40mm drop. Also wanted to...

Hi Folks, New A6 C7 Avant owner, fully intend in lowering the car and had planned on fitting coilovers, spoke to FK Coilovers today and their item is not Drive Select compatible. I was wondering if I do lower the car will this affect the drive select system? Or can someone with the same...

So I'm after a set of the absolute lowest lowering springs. After much research my choice has been narrowed down to: H&R 28810-1 H&R 28826-2 I'm aware that (28810-1) is a revised version but I still haven't been able to figure out a definite answer as to which of the two above achieves the...

How much it cost roughly to get lowering springs fitted?

I have an A3 Sport 1.4 TFSI 122 hatchback 8V pfl. I’m looking to buy Eibach Pro lowering springs but I want to make sure I get the right ones as there’s so many variants. Axle loads on my VIN plate are 1- 920kg and 2- 930kg. According to Demon Tweeks, Eibach EIBE10-15-021-01-22 will fit in...

Recently purchased my first Audi, went with an S3 saloon with a fairly decent spec and in Nardo Grey! I've had a few Golfs in the past but absolutely loving this so far. Few security bits in place and then on to making it my own a little bit. Looking to purchase some lowering springs, I've...

Going to be ordering coil overs soon for my a3 , while I’ve got all 4 corners dismantled is there anything I should be replacing or would benefit from being upgraded, like any bushes known for going bad? Also if there anyway of telling what strut size I need, 50mm or 55mm, without taking mine...

Hi guys, i am looking for a set of lowering springs that will retain the day to day driveability as its my daily, so not too sure as to how low to go and what brand, have been looking at H&R and Eibach mostly Also I need advice on fitting and any other hardware that I require Thank you all a...

Hi I have a 3dr s3 8p facelift. Looking to buy ap coilovers. Can people show me how low they go?! Thanks

Hi there, I am new to the car scene and I have deciding I want to lower my Audi on 19inch wheels and coilovers, not decker just so the wheel arch gap is closed and on top of the wheel. I am needing help on doing this, I need to know what I have to run wheel size and spacers etc.. Any help...

Hey guys, 2011 a3 8p black edition, standard 18" rotas but I want her lower... what brand do you recommend and lower by how much? Cheers.

I just thought what would happen if someone installed lowering springs developed for a lighter model to a heavier one? Would someone's car drop lower than if they installed the right springs? Let's say a car had an axle load of 1065/1005 (front/rear) and someone installed springs that were...

Okay to give as much background as possible, I currently own a 2012 facelift B8.5 FWD S-line. I recently purchased a set of 20” TTRS/Rotor alloys 9J wide. They are running 255 35 Zr 20 tyres and the car is running on standard suspension. I’m looking to give the car a lower look without...

Hello. Im wondering about lowering my car. And the option i have (in Norway) is springs or coilovers. Its difficult/impossible to get air approved by the DMV. I also dont want coilovers because i want to be able to use the adjustments in the car. Does anyone have any experience with mounting...

morning all , Recently picked up a very nice A4 Quattro Special edition S-line and tho an s-line it still sits to high I reckon so I’m looking at lowering it that little bit more. I’m looking at H&R springs initially. So come on, if you’ve got an s-line with H&R springs post up a pic so I can...

My car is lowered 1" and I have replaced the upper tie arms with adjustable tie arms to correct the camber after lowering (2010) However, I have always had problems getting the car aligned - when the rear camber is bought into spec the rear toe angle is out of spec (toeing in). I have heard...

Hi is anyone here running eibach pro lowering springs Just wanting to know what the ride was like and how the drop is thanks

Hey Guys, So here is my latest modification on the facelift C7.5 S7. The Cete Automatic Suspension Control module allows you to adjust the height of your AIR SUSPENSION system by a factor of +30mm to -40mm from the OEM height, using an iPad app (Android on the way) connected to the ASC module...

Hi Peoples, I have heard that MSS Kits are about to release their fully adjustable springs for the A3, S3 & RS3 8V. Has anyone used them before on their TT, TTS, VW Golf (GTI or R32)? I had an set on my TT and the ride quality was really good and the car had a nice ride height too, so I have...