Zafi
Registered User
So I looked through all the coding and adaptations for any mention of Start-Stop
Then I tried
[01 ENGINE] -> [Coding - 07] -> [Long Coding Helper] -> Byte 6
Bit 0 untick
[01 ENGINE] -> [Adaptation 10] ->
Channel Activation of Start/Stop function, change stored value to Not Active
[02 AUTO TRANS] -> [Adaptation 10] ->
Channel Deactivation of Start/Stop Function, change from Not Active to Active
[46 Central Conv] -> [Coding - 07] -> [Long Coding Helper] -> Byte 11
Bit 2 untick
Anyhow the coding did not work, could not get it to accept a change to [01 ENGINE] -> [Coding - 07], came up with "Coding rejected Error 31: Request out of range
All others changed OK, started the car and it put a message on the dash that said "Start-Stop system: System fault. Function unavailable." but a test drive showed the ****** stop start still worked!
Then when I plugged it to change the stuff back, the 2 adaptation changes I made had already changed back by themselves.
Any ideas anyone?
Then I tried
[01 ENGINE] -> [Coding - 07] -> [Long Coding Helper] -> Byte 6
Bit 0 untick
[01 ENGINE] -> [Adaptation 10] ->
Channel Activation of Start/Stop function, change stored value to Not Active
[02 AUTO TRANS] -> [Adaptation 10] ->
Channel Deactivation of Start/Stop Function, change from Not Active to Active
[46 Central Conv] -> [Coding - 07] -> [Long Coding Helper] -> Byte 11
Bit 2 untick
Anyhow the coding did not work, could not get it to accept a change to [01 ENGINE] -> [Coding - 07], came up with "Coding rejected Error 31: Request out of range
All others changed OK, started the car and it put a message on the dash that said "Start-Stop system: System fault. Function unavailable." but a test drive showed the ****** stop start still worked!
Then when I plugged it to change the stuff back, the 2 adaptation changes I made had already changed back by themselves.
Any ideas anyone?