Not necessary to jack up the rear and remove wheels - wheel arch screws are accessible with wheels in place with Torx bit and right angle ratchet. Worked fine for me.its quite involved, i took mine off when i swapped over the lower valance. first the car needs to be on axle stands with both the rear wheels off then there are 2 or 3 screws in each wheel arch the fix into the end of the lower valance. There are 2 screws underneith right at the back(you cant miss these). iirc you then need to remove the boot floor,the left and right boot sides and the amp and sub have to be removed, there are 5 nuts each side to remove. i think i also had the luggage hooks out also.Then its just a case of pulling it off the car. i know it sounds quite a lot to do but it only takes 45mins or so
Yes on the inside - target type cross and circles mark the 4 spots - also on the front bumper too!Is it right the rear of the bumper has pre marked locations for the sensors??
Not necessary to jack up the rear and remove wheels - wheel arch screws are accessible with wheels in place with Torx bit and right angle ratchet. Worked fine for me.
Can you fit the Audi proper ones without coding them, or is it just easier to buy a normal kit and do the wiring them into the reversing lights thing......... I', thinking about it having an effect on DIS / Bulb out kinda stuff....