Hi all,
So I have replaced my HVAC unit as the previous unit died, had the component protection removed today by the very helpful guys at CTCarsLtd (I recommend them to anyone near Guildford) but I cannot get the basic settings to work.
Connected using VCDS, then went to HVAC>Basic settings>Go. All it does, is say start in VCDS but cannot hear any of the motor flaps moving and the screen on the HVAC unit just flashes 3 times and then VCDS says aborted. Tried it numerous times but won't work. Checked fault codes and all I can see for the HVAC is 'no basic settings'. Am I doing something wrong or is this not the correct procedure?
The HVAC unit works as I can turn on the heated seats or the rear screen, etc but will not let me use any of the other vents apart from the windscreen. Even if I turn the fan speed down and set it to say my feet only, it reverts almost instantly back to the windscreen at nearly full speed....this I assume is because of the basic settings not being set?
Any ideas?
Thanks
So I have replaced my HVAC unit as the previous unit died, had the component protection removed today by the very helpful guys at CTCarsLtd (I recommend them to anyone near Guildford) but I cannot get the basic settings to work.
Connected using VCDS, then went to HVAC>Basic settings>Go. All it does, is say start in VCDS but cannot hear any of the motor flaps moving and the screen on the HVAC unit just flashes 3 times and then VCDS says aborted. Tried it numerous times but won't work. Checked fault codes and all I can see for the HVAC is 'no basic settings'. Am I doing something wrong or is this not the correct procedure?
The HVAC unit works as I can turn on the heated seats or the rear screen, etc but will not let me use any of the other vents apart from the windscreen. Even if I turn the fan speed down and set it to say my feet only, it reverts almost instantly back to the windscreen at nearly full speed....this I assume is because of the basic settings not being set?
Any ideas?
Thanks