That looks epic! The RS3 only fits the sport back doesn't it? ..
quality what years yours? trying to get something for my 2006 SB
perfect whats the part nos and cost? easy to fit DIY
Nice. You planning to sort out that arch gap at the back??
have u got bigger than normal exhaust holes?
I read about this on another thread but is says not for an sline which mine is, whats the diff between sport and sline??
Audi A3 Sportback Rear Bumper Spoiler S3 Look Tuning -GB- | eBay
was it Perth Audi you ordered your from?
Do these take much to fit, I have a 2007 s-line sportback?
will that fit my tdi 2007? i have a non s-line and by the looks of my bumper you can say it would be in two parts.
see here:
http://www.webdesignforyour.biz/nbo/2.jpg
from that angle i would say that it would fit but would get a second opinion if i were u
I heard it's not a straight fit for 3 door cars, some mods have to be done to make it fit.Thanks, no it fits any s3 lower spoiler so would fit 3 door
Hi mate , referred to your thread and looking good
Just like your rear bumper , just to clarify , take of my rear splitter on current bumper and attach the diffuser and valance and no modifications required ?
I heard it's not a straight fit for 3 door cars, some mods have to be done to make it fit.
Yup no mods needed, it clips off easy, I found it easier once I had uncliped the actual bumper from the rear arch I thought I'm going to need to remove the rear lights but didn't need to unclip the bumper that far up it's really just the sides at the rear arch, and as stated there's a screw each side behind the wheel liner that holds the spliter to the bumper it's a bummer to get to but with the arch unclipped you can slip your hand down to it, yiy can see it when you stick your head under the car but it's impossible to unscrew it from underneath as the screw faces down you will see what I mean
Yes the one in this pic is the standard s3 one was made for the valance I have the rs3 one where u need to trim the valance but only parts that you can't see
I don't have the part Numbers to hand at the moment I'm afraid
That's not an S3 lower rear valance they have sold you mate it's an RS3 one.
The S3 lower valance section needs a lot cut away from it to allow the RS3 rear diffuser to fit properly, I know as I fitted one to my S3 Sportback.
I'm also almost certain the RS3 diffuser only fits a Sportback S3 rear lower valance (with the modification I mentioned above) or an RS3 valance like you have, but not sure either of these fit a 3 door, the bumpers are a different shape.
Could be wrong but would suggest 100% clarification for 3 door people before going shelling out £300 on bits.
That's not an S3 lower rear valance they have sold you mate it's an RS3 one.
The S3 lower valance section needs a lot cut away from it to allow the RS3 rear diffuser to fit properly, I know as I fitted one to my S3 Sportback.
I'm also almost certain the RS3 diffuser only fits a Sportback S3 rear lower valance (with the modification I mentioned above) or an RS3 valance like you have, but not sure either of these fit a 3 door, the bumpers are a different shape.
Could be wrong but would suggest 100% clarification for 3 door people before going shelling out £300 on bits.
There is only one valance I bought it and cut it and fitted it all myself without the use of a bodyshop was one long cut that was all just to remove the center section
There's a proper RS3 lower valance that fits the RS3 rear diffuser properly without cutting mate.
I never realised you had cut yours, fair enough, easier off the car I bet