Better later than never but here goes
Forgot to take some pictures too...
#1 Remove trim from the wider end, pull it out on level away from the door, when you get to the end pull towards the windscreen..see number 2
#2 pull towards windscreen to get clear of the lug
#3 Remove these four screws, also 2 more screws (1 under the hand rail and 1 right at the bottom under the door card)
#4 & #5 are for drivers side only...1 right at the bottom again on drivers side too.
Now pull the door cards off.
Start from the bottom and work your way around to the top...dont be scared just pop it off lol (ill be suprised if none of your clips break lol)
Once all have popped out lift up so it comes out at the window ledge.
Be carefull as it is attched with a few things
#6 Remove the door handle clip
#7 remove the speaker conector (closest one to the edge and also Remove the orange connector (the bit we want)
Push the orange tab down to release it and simply pull it out..downwards.
#8 Remove purple cap (slide if iff using pliers..mine was quite stiff)
#9 make note.of the number layout on the face of the grey block (1-16/17-32)
Slide the white block out and connect your (negitive to 21 posstive to 16)
+ should push straight in
With negitive you have to
Pigy back of the existing wire.
Up to you how you do it be due to not having much space i did as follows
(Carefully split the black tape to gain more wire cut and connected my new puddle light wire to it, taped it back up and hey prestro...i done this method on all four doors..see picture 11)
Now the rears, all the same principle as the fronts,
#10 Remove the small yellow block, pull out ..take note of the numbers
#11 possitive is in 2..push straight in
Negitive..again pigy back off the existing wire...same again...i split the tape and gained more wire..tape it back up... bobs ya uncle fannys ya aunt!
Now this is where you get all your P.P.E out goggles gloves dust mask fire extinguishers etc lol
#12 Cut this out...take your time dont cut too much, bit by bit and keep checking for a snug fit. I used a dremel and then used a sander bit to smooth off the edges.
(You do pretty much need to cut it all out tho lol)
#13 Connect up and your ready to go
P.s on other how too's I have read
1 says you need vagcom...no you dont
Another says you need to disconect the relays or something (fronts in the footwell..rears in the rubber boot between the doorl...no you dont lol...well i didnt need to.
I simply followed those steps, shut my doors..locked it, un locked it and happy days it was done
Links to what i bought
Puddle light adaptors
http://m.ebay.co.uk/orderDetails?itemId=151897135288&txnId=1384257115005
Logo lights..x2 (i wanted 4)
Amazon product (in person you can see both lights very well..just in photos the red audi doesnt show aswell as the white rings.