Lift tail gate remove rubber boot seal around bottom above bumper carefull lift up plastic trim that goes under seal (says in manual to remove this completely but if carefull dont need to as if you do will need to be bonded down) about 6 hex screws under there best to leave one in middle whilst undoing others then undo the hex screws that go through the wheel arch liners into bumper I found it easier to remove both rear lights and undo the bolts that secure the trim peices under lights 2 more hex screws 1 above exhaust cut out and 1 other side that secure bottom edge of bumper and "hey presto!!" thats about it, to remove bumper from car best to get mate to help if someone near and handy can be done on own just get hold of each side where goes into wheel arch liners and will come out each side them pull away from rear.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.