Ive just had the white dis clocks fitted and coded to my 07 plate 2tdi. Looks so much better and everythings working as it should but been told my clocks dont support the sweep. They came out of a 60 something plate car and i remember him sayinv they was hard to do because of the micronas? Any light in this would help because i started this mainly for the needle sweep and im so far £120 in also how do i activate the boost gauge via vcds?
Needle sweep and boost gauge
- Thread starter Louis Scott
- Start date
Who did you find to do in the end?
Did the immo remain intact or is immo disabled?
Mileage corrected?
Unless it's S3 it won't support needle sweep.
Did the immo remain intact or is immo disabled?
Mileage corrected?
Unless it's S3 it won't support needle sweep.
Boost gauge wasn't std on the S3 - only with an aftermarket module, and even then digital boost gauges are hard to read. Better off with a vent gauge ... https://www.ebay.co.uk/itm/163913594823
(this is the mount for a gauge btw!)
(this is the mount for a gauge btw!)
