Hi all, I'm doing a MFSW installation on my 06 B7 DTM and I wanted to see what slip ring I had installed (as looking at the config on VCDS it has the settings enabled for MFSW previously although not now fitted and I wanted to see if the right slip ring was fitted). I removed the slip ring to see what the part number was and then reconnected it. Since I did this the airbag light has been illuminated on the dash. I've checked the connections for the slip ring, the airbag loom etc and all looks ok. I got the standard ESP light on which wet out after the usual little drive and turning the wheel left to right. Before doing this I had a fully working Airbag and Steering wheel/slip ring (i.e. no codes or MIL). I've cleared the codes and the error comes back. I've also fitted a replacement slip ring (4E0 953 541 A) and the error still persists (see below)
2 Faults Found:
00588 - Airbag Igniter; Driver Side (N95)
001 - Upper Limit Exceeded - MIL ON
Freeze Frame:
Fault Status: 11100001
Fault Priority: 1
Fault Frequency: 1
Reset counter: 255
Time Indication: 0
01587 - Igniter 2 for Airbag; Drivers Side (N250)
001 - Upper Limit Exceeded - MIL ON
Freeze Frame:
Fault Status: 11100001
Fault Priority: 1
Fault Frequency: 1
Reset counter: 255
Time Indication: 0
Is there a re-calibration I need to do after removing the slip ring? If not has anyone else experienced this and fixed it? Any help appreciated.
2 Faults Found:
00588 - Airbag Igniter; Driver Side (N95)
001 - Upper Limit Exceeded - MIL ON
Freeze Frame:
Fault Status: 11100001
Fault Priority: 1
Fault Frequency: 1
Reset counter: 255
Time Indication: 0
01587 - Igniter 2 for Airbag; Drivers Side (N250)
001 - Upper Limit Exceeded - MIL ON
Freeze Frame:
Fault Status: 11100001
Fault Priority: 1
Fault Frequency: 1
Reset counter: 255
Time Indication: 0
Is there a re-calibration I need to do after removing the slip ring? If not has anyone else experienced this and fixed it? Any help appreciated.