Are you not better with this one?
http://m.ebay.co.uk/itm/271731982600?nav=WATCHING_ACTIVE
http://m.ebay.co.uk/itm/271731982600?nav=WATCHING_ACTIVE
I now have the switch mount and two blanks fitted so I'll take a pic later and post up.
Are you not better with this one?
http://m.ebay.co.uk/itm/271731982600?nav=WATCHING_ACTIVE
What year is your car? Do you have access to wiring diagrams? Do you know if your car supports PDC on the convenience or drivetrain can network?
I unplugged the connector from the can gateway, looks like the one you have pictured, stripped back the insulation and just split and re-soldered the cables.
Can't remember which ones, but it all worked fine
I didnt get a kufatec manual to download!
I can have a look on Elsawin for the pin locations
You also need a buzzer for the front.
You can check the module no.with vcds if you have access to it.
It plugs into the module loom, along with the pdc button and illumination wire, the loom then continues onto the front pdcthanks for the tip mate, i just ordered one. does this plug in to the loom that runs from the module or loom that the sensors connect to please?
anymore tips, keep them coming cheers...