Hey everyone, so managed to gets lots done this weekend, which I’ll update my build thread soon. But here’s my question....
Finished my PCV simplification and started the car, runs for about 2-3 seconds and dies, check fuel, spark all seems fine. Then I decided to unplug the MAF. Car starts and runs perfectly! The MAF is relatively new and worked faultlessly before I did the PCV changes. I’m getting the code P0102. Suggests there might be a fault with wiring, MAF sensor or intake air leak? If I had an air leak, would it just stall the engine completely...... I’ve had an air leak before and the cars run rough, but never not started.
Any advice or suggestions?
Ash
Finished my PCV simplification and started the car, runs for about 2-3 seconds and dies, check fuel, spark all seems fine. Then I decided to unplug the MAF. Car starts and runs perfectly! The MAF is relatively new and worked faultlessly before I did the PCV changes. I’m getting the code P0102. Suggests there might be a fault with wiring, MAF sensor or intake air leak? If I had an air leak, would it just stall the engine completely...... I’ve had an air leak before and the cars run rough, but never not started.
Any advice or suggestions?
Ash