Bottom end bearing

[SamHendry]

hello folks Purchased a set of kolbenschmidt shells for my new rods but on closer inspection it would appear the shells that I've been supplied don't have the self positioning tab that slots into the the notch on the rod. Have I been supplied the wrong bearing? I'll include a link to the ad. Car is s3.

http://www.ebay.co.uk/itm/252608720962?_trksid=p2057872.m2749.l2649&ssPageName=STRK:MEBIDX:IT

 

[<tuffty/>]

TFSI are tangless... if you have tangless bearings then they are wrong... 1.8t 19mm pinned OE rods are tangless crack rods are tangless... TFSI are much the same (bigger pin obvs) but you want tanged bearings to prevent them spinning

<tuffty/>

 

[SamHendry]

Thanks for the reply tuffty. I'll need to send these back. Pita lol

 

[badger5]

hello folks Purchased a set of kolbenschmidt shells for my new rods but on closer inspection it would appear the shells that I've been supplied don't have the self positioning tab that slots into the the notch on the rod. Have I been supplied the wrong bearing? I'll include a link to the ad. Car is s3.

http://www.ebay.co.uk/itm/252608720962?_trksid=p2057872.m2749.l2649&ssPageName=STRK:MEBIDX:IT

yes. wrong ones supplied