Recent content by ReflectRuss

Its not really about the corners cut as they are obvious, its the solvents in the spray wrap that have affected the paint beneath, also i dont mention products because its just not cricket, however there cant be too many options when it comes to spray wrap. Didnt take it as a dig fella.

Wouldn't go down the Plastidip route A3 from HELL - Detailing World

you still looking fella www.cardetailingsheffield.co.uk, www.cardetailingsheffieldyorkshire.com

Not going to try and poach work off Jim but if you dont have any luck guys I am moving into a new unit at the beginning of July just off J30 of the M1, like i say give Jim a chance to get back to you, sure he's busy and will probably have a shed load on his detailing platter. Having said that...

For some strange reason It wont let me send a PM but by all means get in touch....I am also a supporter over on RS246 as well as DW....

Reflectology....BMW M6....pull up a pew and grab a brew.... - Detailing World

depends mate....if they go through insurance....quite a bit but they may get a low end repaint of the panel for about £150 maybe less but your not guaranteed its gonna be any good....if I were to do something in dark grey and around 10inch long I would be looking at around £100 with a 90%...

A bit far for me to come, although i do a lot of travelling for detailing but you could always take a look at this that i have put together....Scratch and stone chip removal.... - Detailing World

wouldnt go with any Zaino product in these temps unless you are applying it indoors...whilst it is a superb brand and i use it myself it doesnt fully cure in temps below 8c....stick with Colly 476 and when it warms up get a kit of Z2,ZFX,Z6 and Z8....that lot will cost about £50 but will see you...

get someone who would travel....

used to work in Stoke....dont know of any detailers there but its not too hard to get to...straight run through Buxton I think....

Search for vehicle detailing mate...everything should be explained on a detailers website and it will also give you an insight into what work is involved....also if you do go down the pro route, dont just go for the ones that are cheapest...not saying get the most expensive out there but there...

There is mate yes, but its a job for a pro as heat generated from machine polishing the glass can warp the laminate layer....

I have just done Bez101s Focus St with Permanon...with it being a protection I very rarely take any pics but he may have and may post some up...it does look special....

I dont mind travelling mate and I have just signed up to Ceramishield which has just been approved by Audi technicians....I also have a technique for stone chips as well....if you are interested send me a PM