Recent content by 203132

Yeah I'm on the 17's. They don't make 225/35/18s for Sydney. They make 40's though...

Factory ContiPremium Contact 2 swapped to Bridgestone S001's. Road noise noticeably louder. Performance destroys the Conti (obviously, not a sports tyre, don't even know why it came with those tyres). Can't get any Michellin tyres, they don't stock S1 wheel sizes according to website. I would...

wow, I really like how bassy it is! Great choice

What a great build. Love the instagram too! Man I love the cut out sections of the rims spokes, great colour. :rockwoot:

Also, check if there is really bad judder when you full lock reverse from start. It will judder but check if it's acceptable or not. I think it's the diff at the back?...not sure

Remember to check if the fuel lines rattle against the body in the engine bay during a cold start. Not an issue reliability wise, but it could mean a day at the garage to fix. Can probably ask if the issue has been addressed.

that's only 6 months away! might as well get OEM since they don't require much bedding time.

From the looks of it, Shocker has metallic flake in the car's paint. It was probably more than just 2 panels to blend everything in.

ouch. That is quite a lot of coin. I hope karma comes around to the ******* who did it!

From my experience, if it's hazy, that means you need a finer grit polisher. Not sure what it will be like if it has gone through the clear. I would assume that it would be flat black.

Just wondering what the wheel alignment specs are for the S1? There aren't that many S1's on the road in Sydney so I'm hoping that the next time I get a report, I can make sure I didn't get an A1 wheel alignment set up. Also, has anybody played with their set up for sharper response?

ask your dealer. I asked mine and apparently any modifications will ruin my bumper to bumper warranty. They differ.

https://www.seasucker.com/collections/racks/products/talon I have yet to use these myself, but I was very tempted as they show great promise. Downside is that you will have to clean the roof before you install but taking them off is a breeze.

chillout, just appreciate the well made video :whistle2:

I've looked into this, asked the dealer about it. They were like, "it must have hill hold assist" and they took it in for a few hours and came back shocked to find out that they couldn't do anything about it. They first said, it should be possible because it just uses the electronics to engage...