Help error only since miltek racedownpipes fitted 16395-bank 1 camshaft a (intake) ****** set point

[leeunderdown]

Hi all,

I'm getting the following error

16395-bank 1 camshaft a (intake) ****** set point not reached ( over advanced) P0011-008-implausible signal-intermittent

18010-Power supply terminal 30: voltage too low P1602 -002- lower limit exceeded-intermittent



in vcds and the warning light coming on after having the miltek with no cats downpipes fitted?

I wasn't getting this before having the miltek race pipes (cat less fitted) the ecu has got a jhm remap (awsome ) so I'm after a set of diagnostic instructions please.
If it helps the mpg has also started to fluctuate all over the place again, only since the downpipes where fitted. Some time saying 20 mpg, sometimes 198 mpg ?

Is it possible the mechanics have caught or damaged something while fitting the downpipes? As it seems weird I didn't get this fault before?

Not looking to point any fingers, I'm happy to diagnose and fix myself just would like some help please.

 

[dualmono21]

which car and which engine
need a little more information

 

[S4_dan]

18010 is related to the battery. Possibly the wires were removed. Or the battery is failing or the alternator is failing.

I'd clear all of the codes and then drive the car again. It is possible wire damage has been caused when the exhaust as being fitted.

But clear the codes and see if they come back.

 

[jimmyb592]

Definitely clear and retest. Bring a mechanic myself, I'm sure a lot of customers are shocked when they ask what we found with there cars/vans and we tell them we have cleared the dtcs and u need to monitor it to see if it faults again. Too many dtcs will just lead u to a fault that isn't there