Fitted my genuine RS4 gear knob and red alcantara gear gaitor to match the dash trims. very happy with the result.
What media system is that John? Looks good!
Haha, well saidReplaced rear footwell bulbs and wiper blades. No-brand to Bosch, only the best for my baby
Finally got round to doing my DRL job, used the dogs with 20w cree's wired through a 5 port relay so they go OFF when side or headlights are turned on.
Fitted this...View attachment 64700 View attachment 64701
Where did you put the esp switchI've fitted 2 new wings and put an extra cup holder in place of the card holder and esp switch. Who ever designed the cup holders for them must not of had any mates
What engine do you have frank and what it easy?Replaced the front engine mount (snub mount). Not a huge difference side by side but it seems to have reduced the take-off judder a little on the 40 degree hill the house is on!
View attachment 66114
Main engine mounts to be done when I do the timing belt in a couple of weeks.
Sorry to here about the clutch issues!View attachment 66140
Full stainless fitted, made a huge difference to the car even before the map. Had to call the mappin session short as the clutch decided to slip on the first run
Yeah not bad at all. I'm just about at 170k with original clutch as far as I'm aware!It's done 124k so I'll let it off. Torque comes in soo hard with the bv43 I'm not sipprised.we think it started to slip at about 180bhp
No smoke from exhaust at roughly 180bhp so still more tuning to go once clutch is done. Should b able to see close to 200-210 hopefully
I've just cut my back box off for short termView attachment 66140
Full stainless fitted, made a huge difference to the car even before the map. Had to call the mappin session short as the clutch decided to slip on the first run