I have these fault codes on my 2.0T FSi A4.
Anyone offer any advice..
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 8E0 910 115 J HW: 8E0 907 115 C
Component: 2.0l R4/4V TFSI 0080
Revision: --H02--- Serial number:
Coding: 010C0003190F0120
Shop #: WSC 00411 210 91522
VCID: 285BA785E281
2 Faults Found:
008583 - Bank 1; System too Lean at Idle
P2187 - 004 - No Signal/Communication - MIL ON
Freeze Frame:
Fault Status: 11100100
Fault Priority: 0
Fault Frequency: 1
Mileage: 184798 km
Time Indication: 0
Freeze Frame:
RPM: 781 /min
Load: 20.8 %
Speed: 5.0 km/h
Temperature: 90.0°C
Temperature: 21.0°C
Absolute Pres.: 990.0 mbar
Voltage: 14.224 V
001287 - Idle Control System RPM: Higher than Expected.
P0507 - 001 - Upper Limit Exceeded - Intermittent
Freeze Frame:
Fault Status: 00100001
Fault Priority: 0
Fault Frequency: 1
Mileage: 184843 km
Time Indication: 0
Freeze Frame:
RPM: 880 /min
Load: 14.5 %
Speed: 0.0 km/h
Temperature: 95.0°C
Temperature: 34.0°C
Absolute Pres.: 990.0 mbar
Voltage: 13.843 V
Readiness: 0000 0000
Anyone offer any advice..
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 8E0 910 115 J HW: 8E0 907 115 C
Component: 2.0l R4/4V TFSI 0080
Revision: --H02--- Serial number:
Coding: 010C0003190F0120
Shop #: WSC 00411 210 91522
VCID: 285BA785E281
2 Faults Found:
008583 - Bank 1; System too Lean at Idle
P2187 - 004 - No Signal/Communication - MIL ON
Freeze Frame:
Fault Status: 11100100
Fault Priority: 0
Fault Frequency: 1
Mileage: 184798 km
Time Indication: 0
Freeze Frame:
RPM: 781 /min
Load: 20.8 %
Speed: 5.0 km/h
Temperature: 90.0°C
Temperature: 21.0°C
Absolute Pres.: 990.0 mbar
Voltage: 14.224 V
001287 - Idle Control System RPM: Higher than Expected.
P0507 - 001 - Upper Limit Exceeded - Intermittent
Freeze Frame:
Fault Status: 00100001
Fault Priority: 0
Fault Frequency: 1
Mileage: 184843 km
Time Indication: 0
Freeze Frame:
RPM: 880 /min
Load: 14.5 %
Speed: 0.0 km/h
Temperature: 95.0°C
Temperature: 34.0°C
Absolute Pres.: 990.0 mbar
Voltage: 13.843 V
Readiness: 0000 0000