No not the J Jo one. Cough..
So yesterday put foot on clutch just before turning ignition key and snap! Broken plastic bits and no clutch..
Today after pulling it all to bits I found that the pedal housing had failed. A new pedal was picked up from Audi for only £22.
Given all the other nightmare scenarios I read about last nite I'm thinking I might be lucky here.
Now the thing is I also spotted that the master cylinder push rod is now slightly bent near the ball joint. I'm pretty sure this a result of the push rod poking out the back of the the housing as the pedal hits the floor..
What I want to know should I try to straighten the push rod or leave it alone??
So yesterday put foot on clutch just before turning ignition key and snap! Broken plastic bits and no clutch..
Today after pulling it all to bits I found that the pedal housing had failed. A new pedal was picked up from Audi for only £22.
Given all the other nightmare scenarios I read about last nite I'm thinking I might be lucky here.
Now the thing is I also spotted that the master cylinder push rod is now slightly bent near the ball joint. I'm pretty sure this a result of the push rod poking out the back of the the housing as the pedal hits the floor..
What I want to know should I try to straighten the push rod or leave it alone??