Howsit guys
I'm new to the forum and From South Africa...
I would like to know if I could replace AWT bottom end with ADR
I know compression Ratio is higher on the ADR but was thinking if I could use the AWT rods and pistons would it work?
I'm open to any suggestions
Thanks in Advance
I'm new to the forum and From South Africa...
I would like to know if I could replace AWT bottom end with ADR
I know compression Ratio is higher on the ADR but was thinking if I could use the AWT rods and pistons would it work?
I'm open to any suggestions
Thanks in Advance
