Hello all,
I did some dyno runs yesterday which produced the outputs below. There was an odd dip in power/torque at around 5000rpm, which then recovered to where you'd expect the curve to end up.
Regardless of any other variables, it always did the same thing, in the same way (stock map, APR stage 1).
Boost, fuel, lambda, temps and everything measured was absolutely fine and showed no weirdness at this point in the run.
The only thing spotted was a deg of timing added at this point, and then backed out again. Logging resolution wasn't great as I was using VCDS.
I'm going to ask about on the APR forum too, but thought I would post here too.
I did some dyno runs yesterday which produced the outputs below. There was an odd dip in power/torque at around 5000rpm, which then recovered to where you'd expect the curve to end up.
Regardless of any other variables, it always did the same thing, in the same way (stock map, APR stage 1).
Boost, fuel, lambda, temps and everything measured was absolutely fine and showed no weirdness at this point in the run.
The only thing spotted was a deg of timing added at this point, and then backed out again. Logging resolution wasn't great as I was using VCDS.
I'm going to ask about on the APR forum too, but thought I would post here too.