Satnav coding,
channel 6
0 - No TMC
1 - Radio
2 - Telephone
3 - Radio or Telephone
Have you checked the instrument cluster coding?
Under adaptation go to channel 62, coding is:-
+1 Radio
+2 Telephone
+4 Navigation
+8 Telematics
So yours should be 5 (1+4)
Here's the pinout of my old symphony headunit
You could use the telephone input, but you'd have to feed power to the mute pin to get it to switch over.
If the wiring is correct it sounds like a coding problem.
To double check the RNS-D is talking to the TMC & the instrument cluster get the navigation screen up and hold down the AS and the down button at the same time and the communications status screen will be displayed.
Having a look...
Is there some special trick to getting the lower hose back on?
I've tried dunking it in hot water and applying washing up liquid and I still can only get it half way on.
I'm having yet more problems with retrofitting the RNS-D satnav.
I had it all working perfectly then had to pull the unit out to retrofit heated seats. Since then the position only updates every 30 to 60 seconds and satnav says I'm not on a digitised road.
I've double checked that the 26pin...
Nearly finished wiring up my retrofitted heated seats using a Kufatec loom.
I've just got to wire in the illumination and ignition live into the kufatec loom. Any advice on where to tap into them and what colour the illumination and ignition live are on a facelift car?
Thanks
Fixed this on the weekend.
The CAN wires that were plugged in to the radio don't appear to communicate with the cluster. Put two pins in the grey connector in positions 5 & 6 and connected these to the TMC module. Satnav now shows directions and location on the cluster :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.