Thanks ScottyP45 you’re right I was being dumb and measuring it wrong! I’ll try again and measure correctly
I thought I had ruled out the abs control unit but that’s because I measured the signal wrong. So if I see a signal on the scope this time then that confirms it’s the abs control unit...
I had a 1 meter breaker bar to do the extra 180 degrees but because the bolts were those horrible torx type I struggled to get 90 degrees.
I’ve replaced the stretch bolts on the front wheels (when replacing the cv boots) which used the 12 spline type bolts and I managed to do 180 degrees on...
I did think of trying this but I don’t know where the connector further up stream is?
I can see the wiring go from the sensor into the wheel arch liner (behind a plastic fuel pipe as it’s on the same side as the fuel filler) but I don’t know the route it takes to get to the abs module?
No the scope is on DC coupling, it’s showing a voltage level of 12V DC but no pulses when spinning the wheel.
The sensors are 2-wire current sensors (not 3-wire voltage sensors). There is usually a pull down resistor in the control unit to convert the current to a voltage which then goes to a...
Six months ago the ABS warning light appeared on the dash of my Audi A3 1.8 TFSi (2007, 8P).
Using VAGCOM I found that the issue was with the rear right wheel speed.
I changed the sensor but this did not fix the problem, so I changed the wheel bearing (which has the magnetic ring on it) and...
Thanks Will you have saved my bacon (almost) !
Unfortunately I destroyed the plastic lift catch and don't know how to get around this, any ideas ?
Im not bothered about the mess I've made to the car, its a piece of sh1t (never buying Audi or VW again) and Im sick of fixing it all the time! I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.