I checked on RossTech and it seemed to be compatible but yeah I suspected that was the case. I'm not too savvy with ETKA, I'm struggling to see how I can check part compatibility.
Hi all,
I've been messing with fitting cruise control to my Audi A3 8P. I have had to fit the cruise wire and change the steering wheel module from 8P0-953-549 to 8P0-953-549-B as well as changing the stalk over.
Once all back together the cruise control worked as intended but I had the normal...
Thanks for throwing some ideas my way to try and help, mines an auto though. Still scratching my head on this one.
The only thing I can think at the moment is that my steering module is the wrong type?
Sent from my iPhone using Tapatalk
I’ve tried putting the codes 11463 and 12233 in the “Security Access -16” section as per guidance I have found on this topic and I just keep getting the following message. Note, this was with the code “12233” after the car had been sat on the drive all night and I had used the car yesterday too...
Did you ever find the cause for you wiper failure? I'm in a similar scenario but nothing to do with aftermarket HID, all stock over here. Wiper motor stopper working after intermittently playing up for a while, but it did stop working all together after I lazily overloaded the wipers by clearing...
Ha, nightmare.
I was under the impression that there were two types of auxiliary heater. 1)The diesel powered type that not all cars are equipped with. 2)The electric type, the one in my pictures above, that all diesels are equipped with? Would you’re a bit have the 2nd type?
Sent from my...
So, as it turns out you didn’t need to remove the board. This shows my lack of knowledge when it comes to electronics.
The board is multilayered and so there isn’t anything to solder on the back. The resistors are essentially a tube that is held on by solder on the top of the board.
Hopefully...
Hi all, I have found that I also have a fault with my Aux Heater, I have stripped down to the point at where I am looking at the circuit board. I have found that mine is also bonded onto the component and am trying to figure out how to look at the back side of the circuit board to see if I have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.