Haha nice. I feel your pain though, I'm just in the process of getting quotes for paintwork on my S4. Might even need new bumpers due to poor repairs in the past.. ££££
Just an update on this, turned out my problem was the same as Scotty described above. I took the car to my mates workshop to use the ramp and we planned to drop the gearbox and replace slave etc. We got to the point where everything was removed from the gearbox (just needed to pull transfer box...
took me two days to do the job last time, think I'm going to have to accept defeat :( my girlfriend is really ill as well so she doesn't think she would be able to do the journey/s anyway. She's as upset as I am tbh she lost her whole summer with me working on the car and promising it would be...
can't see how I'll drop the gearbox again on axle stands in a day.. Don't have a nice concrete floor to lay on this time either, only loose road plainings.
then there is the new gearbox mount bolts and gear oil etc :(
**** sounds like it could be the pressure plate bolts, I used the correct torque but don't remember using locktite. You can hear slave moving and it is quite squeaky.. Tried pressure bleeding etc.
...with some force.. Now with new master cylinder, no noticeable difference in the pedal from previous situations yet can't get any gears! Why the **** didn't I leave it! :( could have easily got it mapped how it was.
I just don't know where to go from here, this meant so much just feel like I...
Can't see the movement cause its in the gearbox, clutch has a separate master cylinder to the brakes and I think i'm going to just fit a new one tomorrow just encase its causing problems.. The issue is air in the system but there doesn't seem to be leaks or bubble coming out when I bleed it
All I need is to get it on Bills rollers Friday :( I don't care whats wrong with it after that.. I've spent the last 4 month spending and working on the car and put in everything I have.. This is such a ridiculous issue to have to mess everything up.
Goes into gear fine with the engine off, clutch in or out. The issue is I only have very little pressure in the clutch, say I force it into gear and lift the clutch 1mm the car will start to pull away so the clutch isn't disengaging fully
I found the issue with bleeding, fluid wasn't getting into the master from the reservoir due to the level being to low despite looking full. I haven't fitted a new master cylinder, i have now bled it and got a pedal back.
the issue is no matter how much i bleed it, it's not good enough and it...
CG motorsports stage 3 clutch kit, replaced slave cylinder at time of fitting (fitted when engine was in pieces). Cars done 300 miles no issue, issues only started after i got back from holiday not done anything.. just got in the car and went to reverse and noticed it was hard to get into gear...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.