Audi A3 Door panel wiring for Bang Olufsen lighting
- Thread starter jim7927
- Start date
B&o lighting is wired into the door controller connector and programmed on with vcds.
Rob did a really good how to guide it’s worth a search
From memory it was pin 12 in the connector but I may be wrong
Sent from my iPhone using Tapatalk
Rob did a really good how to guide it’s worth a search
From memory it was pin 12 in the connector but I may be wrong
Sent from my iPhone using Tapatalk
Yer the 12 pins fine. It powers all the lights on interior door handles and the puddle lights and red warning door lights but the green cable goes to the light bar around the speaker but I don't know where it plugs in. Looks like it's surpose to plug in the control unit or something. It's just a 1 pin plug on the green and blue wire. Just can't figure out where it goes.
Don't know why but mine has from factory one extra single connector on the door module, at least in the Netherlands it is.
On the diagram the speaker grill lamp is L223 connected to pin3 of 20pin-connector (don't know how this situated)
If you don't have it, you can connect it at the door handle light pin3 , or the ambient light pin8 (this requires special coding) both of the 32Connector
Puddle lights is pin 16
On the diagram the speaker grill lamp is L223 connected to pin3 of 20pin-connector (don't know how this situated)
If you don't have it, you can connect it at the door handle light pin3 , or the ambient light pin8 (this requires special coding) both of the 32Connector
Puddle lights is pin 16
Last edited:
Thank you so much for your help. I will try mentioned pins and test it trough MMI before I puting all together. If doesnt work, I would use door handle connector as well. It would be nice to have control on MMi but
Audi A3 8V
