Cruise retrofit- Coding error

All,
I finally got around to retrofitting cruise to my B7 yesterday, following the sticky installation guide on here. The 4th digit coding was changed to a 4 as per instruction but when scanning with VCDS the steering wheel module flagged an 'incorrect coding' error.

Does anyone have any idea on a diagnostic for this? or anything I can try to get it going?
My car DOES have a MFSW & this is operational- In case you needed that info

The cruise kit was purchased from Cardiff Audi and also came with a patching cable, their install guide mentioned this was not required if MFSW is fitted. Is this the case?


Any help is much appreciated.
Thanks
Tom

LawrenceH said:

Have you done the engine ecu also? They both need to be set to cruise enabled or it will flag up a mismatch


Sent from my iPhone using Tapatalk

Click to expand...

No I have not. What sub section does it fall under?
Thanks for the response btw

LawrenceH said:

Stolen from elsewhere on here:

01 - Engine
Coding
'11463'

Mine needed to be done with the long coding number so the above didn't work, here's a doc I made which shows how I coded mine: https://www.dropbox.com/s/oj3n6bwf89c9uga/a4 cruise long coding.pdf?dl=0

Click to expand...

Thanks again for the response. Previous fault codes cleared, new coding accepted in 01. All up and running.