Recent content by shomi951

Audi A3 2008y, 1.9tdi now have 165k. No moods, pulling like first day. Only change what I have is floating flywheel. Gesendet von iPhone mit Tapatalk

Of Course, I have do exactly that when I was put xenon look bulbs. Gesendet von iPhone mit Tapatalk

Thank you for this I will try If anyone can download this or have downloaded please send me because I can not download it immediately because of the rules of the forum.

Exactly I don't have any dexterity to solve this problem, maybe one day...

Hello to every one, I have now the same problem I have bought RNS-E unit from Ebay.de , but the unit comes with a pin (code) when I was contacted the seller they told me that is pin code is not necessary for this unit. When I have put this unit in my car, rns-e want to insert a pin code, then I...

Dear, I have solved this problem, my car was in a workshop regarding replacing a new flywheel, but the repairer doesn't back the connector which stays near to the gearbox. When I was back this connector, everything has worked fine. Also, 2 years since I have this car, I have found out that my...

Dear, In which modul, I can check buzzer? Sent from my iPhone using Tapatalk

Hi NHN, I dont get beep from parking sensor, can you tell me location of that module then I can measure. Thnak you Sent from my iPhone using Tapatalk

Dear All, I have exactly the same problems, when I put into reverse gear, my reversing light and genuine rear parking sensors don't work? I have scanned with VCDS but I don't have any fault for parking sensors. Also, I have changed the bulb in reversing lamps but nothing happened. Car: Audi...

Hello Sandra, I have Audi A3 8P sportback, I hope that I will buy a 8V soon.

Thank you for your reply, I will replace both abs sensors on the rear axle, and scan again with VCDS. Yes, I have put the steering wheel in the right position, but the older wheel doesn't be at a marked point. How I can do new calibration and write in the module.

Dear All, Please help me to solve this fault, everything going fine until I have decided to change my 4 spoke steering wheel to 3 spoke steering wheel. After that and a couple of days, on my board, this error occurred. I have VCDS 17.1.3 and I have tried to clear these faults but they appear...

Greetings to all, I am new here on audi sport net, and also I am sure that is the best way too learn something new and get best information about your car. Sent from my iPhone using Tapatalk

Hello, I have a question regarding this retrofit upgrade to BNS 5.0, I have successfully installed, also I was added GPS antenna from aliexpress. But I don't coding anything, BNS 5.0 still working I don't have maps for my country and I don't have tested navigation yet. If I need something to...

Hello, I have factory towbar installed and coded on my A3, I can post some printscreens from my VCDS if I can help you on that way.