Recent content by Rfclowry

hi sorry new to posting and still don't know if posting in the correct place , but I was woundering if anybody can help me with my problem, I have a Audi Q7 2008 3.0tdi, I have not long after fitting a new compressor because the old one packed in, I tried coding the level height and it's coming...

Hi I’m very new to this forum Just to see if anyone has an idea how to code out the warning error because I have led headlights and fog lights in the q7. Much appreciated if someone could simplify how to do it through vcds Many thanks

went to buy a new dpf as mine is choked up. The seller asked me is it Cordierite DPF or a Silicon Cardide DPF? anyone know which will be in my car it’s a 2008-2009 SE 2.0 tdi 143. ( I don’t know the difference ) Many thanks if can help

Yes bought one and it took code away. Also bought new throttle body and that took the position senor coee off

hi I have a problem with coding my headlights back to standard halogen. I did have upgraded Xenons put in but I’m changing back for MOT ( no high beam ). The new Codes seem to be accepting then when going back in they don’t seem to have changed. Any ideas. Also anyone have the standard halogen...

Great any idea about the code p1588. Any mount solonoid ?

Thank you for fast reply. Sorry it’s the 2008 2.0 143 tdi engine

hi I have 2 fault codes if anyone could please help. As i have the engine management light on And anternative engine management on ( when glow plug lights flash when driving) the codes are P1588 00 (044) open circuit and throttle position sensor (g69) P0122 00 (175) signal too low. Any ideas on...

If this is not suited may you tell me which one is. And how you go about it? I just tryed codes from other forums if you could maby help me with this also as I have no idea. If you can help it will be really much appreciated

Mine don’t seem to be coding !

Hi dose anyone have the codes for this thanks

hi iv posted a few times but no one seems to have any ideas. I changed my headlights from halogen to xenon. I had them fitted into the control module but when I went to get someone to code them. the codes seem to be getting knocked back and not working, it was just reseting them when going back...

hi I need help changing my halogen to bi xenon. I have them in and they don’t seem to code. My module number is 8k0 907 063, but I have seen people putting like 8k0 907 063 a and 8k0 907 063 d but mine don’t seem to have a letter after it would this effect? I have no clue, drls are not working...

Hi mine was the amp in the boot being water damaged, had to send it away to bose expert repair in Edinburgh, spot on service. 1/4 price of a new one.