Recent content by Oli250

Same issue as @Maniek in the end, I had to get the valve & motor replaced.

My 1.6TDI threw an error today while driving, pulled up at a red light and the DIS showed a message that the auto start/stop system was disabled due to an error. Shortly after the glow plug light started flashing. The flashing glow plugs was accompanied by a complete loss of boost from the...

This will work if you have or are looking to install the Audi Sound System. I'm not sure if this would enable the menu on the B&O system.

To update your firmware you will need to download the correct version onto an SD card and use the developer menu on the MMI to run the update, there's plenty of tutorials on youtube for that if you need a guide. If you want to try editing the 0x03b address it would just be the subwoofer...

Hi, yes if you used this method to enable the *** you will also need to amend channel specific settings in 0X003 (gain, delay, EQ). I used a parameter set from another 8V with *** and copied in the relevant parameters so the sound is as stock. I'd probably suggest trying to get hold of one for...

Sorry I'm not sure if this would work for the B&O, the 0x30 dataset is only used on systems using the internal amp. The 0x3b dataset is still used with B&O so you may be able to add the subwoofer gain range through there but I don't know if this would actually work. Is your MMI on the latest...

Ah would ah would expect you to notice it from the drivers seat then. I installed the wheel sub as it was a much easier retrofit, I never had the shelf sub so couldn’t say if there was a difference but imagine it’s better. Perhaps I’ll upgrade at some point

Have you tried listening to it up close to make sure? I installed the spare wheel sub for the hatchback in to my saloon and it was hard to tell tbh, it was working though.

I think you'd need VCP if not doing it this way, perhaps you can with ODIS if you can flash the right parameter sets.

Hi, I’m not sure. From what I’ve read I think this way of activating the subwoofer control is only for the MIB2 as the 0x3B address doesn’t exist on the MIB1

Go to settings -> info and there is a tick-box there. Just the standard OBD-II / EOBD under Audi is fine for this.

What does the data look like before you import it? It should be the same as the hex code shown in the app. I copied the data out of the text box rather than exporting it (as circled in red before). I pasted that into an email, on the computer copied the code from the email into a .txt file...

OK I just had a look, forgot the hex code copied out from Car Scanner already doesn't have whitespace in it! If you try and copy + paste the text directly into 010editor you'll notice the values change. You need to save the hex data into a new .txt file, then in 010 editor go to file -> import...

I never had any issues with using the editor or templates, have you created the new file as a hex file and deleted all the whitespace characters?

Hi Assume you are using the Car Scanner app, not the Carista one? Should be as below