Recent content by Dusty Des

I retrofitted genuine Audi cam and picture is perfect. 2017 A5 sportback

Didnt put full story. Bit long. The fuse space has a piggyback fuse in for dash cam. (will be sorted) I absolutely hate the ****** things but couldnt get the fuse board out to fit a proper fuse connector. The piggyback had come loose. I did know dash cam wasnt working properly as it was in...

Found problem. Fuse in pasenger footwell. No warning on dash and engine codes gone with carista.

Tried Erwin, too new :-(

Car booked in but still searching out of interest. Found one code that says starter relay which sounds right but I just cant find a list of relays or locations for my car.

Thanks for reply. Car booked into Audi on Wednesday. Covered with Warrantywise

Hi all. Drove car 20 miles today and wouldnt restart. Jumped car and drove home, had alternator checked and charging fine. No dash lights but does now say start stop not working (Its always off I never use it) Fitted new battery and coded. Old battery showing 52% and 11.3V Battery now showing...

I have the f770 you need Ferrite rings, one on power to camera and one on rear camera for problems with dab. There is UK support, my camera locked up with a new sd card and couldnt get it back. Contacted Thinkware and they told me to send to a uk site. They repaired it and sent back free of...

Found this. So they could try and do an update can only work or fail to load. My car is MY2017 and has had the software update to the new Audi Satellite layer that replaced Google Earth and is working perfectly. The criteria is the Video GPU used in the MMI units if your MMI was manufactured...

Yes

Thinking of fitting tyre pressure system. (direct) As Ive already fitted reverse camera and used the can bus under rear seat. 2 can bus wires into same connector. Can I use the same connector a third time. 3 wires to the same can bus pins

I did my old b8.5 but had the right abs. This might help? AudiEnthusiasts Hill Hold Assist Install

I did my old b8.5 but had the right abs. This might help? AudiEnthusiasts Hill Hold Assist Install

I did my old b8.5 but had the right abs. This might help? AudiEnthusiasts Hill Hold Assist Install

You have to use old style red lights as you cant get red lens led light for new sockets. You could use clear puddle lights and replace led with red. I did think about it but decided to go with red door light. Aliexpress Car Interior Red Door Panel Warning Light&Cable Wring harness For A3 S3 A4...