Recent content by demi

Hi guys I was looking for a decent boost gauge location/pod to mount for my A3 TDI, some pics and links would be great. Thanks Demi

do they fit? A mate has a set I could buy but not sure if they are different, springs rates would assume to be different but no idea on the fixings ect. thanks

western

I got some rs6 reps :notme: and they seem to be around 65mm not sure as I cant get the vernier gauge inside, I need to find the right set now as the ones i ordered were 75mm to 57. Anyone had any luck finding them?

ordered :thumbsup:

What is the hub size on the 8p, I bought some alloys but they are a bit big on the hub lip and I wanted to get some spigot rings. cheers

Has anyone done a complete install of bushes to powerflex or polybush type thing? It always bothered me how lose the rear bushes feel although they are not worn or anything. Wanted to know how a change affects comfort, handling and noise if anyone has done a full swap.:sm4:

Had some time to open it up, the mechanism inside where the jet sits has leaked, I installed an o ring last time but it has perished. the boot lock is fine, its just the 2 pin wire had some condensation on it and the copper pin has corroded slightly, took it off a good clean and wd40 on the...

Ah so it is the leaky wiper then, I sealed it last winter! Any idea what prices are for the wiper motor or th lock?

I am having trouble with the boot lock sensor, boot is locked but on the screen coming up as open, alarm keep going off. I suspect there is a leak in rear wiper washer, is this a known fault? Left my ca unlocked today!

Shocks do not tend to be weight rated, springs are as they take the weight and major load. I would say your stretched tyres from meaty 225 45 17 to 215 40 18 is giving the bounce, also check the bushes, if any of them are damaged the bouncing will be harsher.

Yep Danny is top bloke!

Depends what parts you want, you can get a journal bearing turbo for 600 or a ball bearing for 1200 or a billet wheel ball bearing for 1600..... The V6 has much potential when turbocharged, you will need a good clutch cerametallic twin plate to keep up with the torque, gearbox is good for...

Ok I think I will stick with silver. Next question is would a 8.5 x 19 et 35 work and what tyres are needed to pull it off? I wont be running super low.

Guys got a question, I seen some wheels that I like, they are 19x8.5 et35, I'm hoping these will stick out enough not needing spacers. What tyres would be needed to clear things? I will need to get some springs also to pull it off as at the moment is on stock height:puke: