So I checked the resistance of the g62 and it showed 270 ohm on terminal 1 & 2 and 580 ohm on 3 & 4. Aircon showed around 60 degrees celsius when we took the test. Any thoughts?
I know you can check the gauge but it seems there is a fair chance of damaging the ecu?
Are you sure? this is the...
i justed talked to them, I now suspect they didnt know about it.
I have no running issues at all. Normal consumption, no codes, no lights in dash. Just that the needle stays just to the left of 90 on the dash.
So, a faulty ECT can cause the car to run at 75 degrees?
I Will check wiring tomorrow. it has been like this for a pretty long time since I was in contact with my local Audi dealership and they told me it was fine.
I did mention it, but whatever :)
Could it be that the ECT is faulty because it sends differnet values and the ECU then sets a pre-determined map?
I have seen through vag-com/climate control that the number there reaches 70 before the needle even begins to move.
First threadcreation, yay!
So I have searched the forums for an answer but I found nothing.
I have a strange problem with my car. It's an S3 -02 facelift.
Started with a problem with warm starts and engine light was on (CODE 17704). Swapped the thermostat for a non-genuine and the temp sensor...
Highjacking the thread a bit, sorry :)
My problem is a bit strange. I have a Audi S3 -02. The thermostat has been changed for a genuine one along with a new temp sensor because I got the "Error in mapped cooling system".
Now my temp will rise so the needle is just to the left of 90 when on a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.