I have had my 3"dp installed for a long time now, however, i get both o2 sensors fail when i do the readiness test (and of course cat fail) will this effect how she runs?
I put on a FMIC about 4months ago with bodgy pipework, when the pipes were holding she boosted nice and hard (most of the time...) since putting in an aluminium setup, definitely air tight, its running bad at idle, limp mode is always in effect, ideas guys?
New maf, new dv, new n75, catch can, inlet mani is sealed tight, all hoses are new and sealed, so, bad actuator?
I put on a FMIC about 4months ago with bodgy pipework, when the pipes were holding she boosted nice and hard (most of the time...) since putting in an aluminium setup, definitely air tight, its running bad at idle, limp mode is always in effect, ideas guys?
New maf, new dv, new n75, catch can, inlet mani is sealed tight, all hoses are new and sealed, so, bad actuator?