kanecullen89
Registered User
Hi all,
I am posting this audio question on here because its a fairly urgent request and I know replies can take a while on the ICE section.
My Concert 2 stereo is knackered and basic. Only plays basic CDs and the volume control is knackered. I have a Sony GT710 stereo lying around with Ipod control so I'm going to install that (no going to look great but cheapest way for me to get good working audio).
This is a picture of the wiring:
1 is the amp remote wire from the headunit.
2 is the ignition switch from the headunit
3 is the power feed from the antenna
4 is the amp remote 12v switch from the connect 2 ctsad003 harness
Now I know that I need to connect 1 and 4 together to get the factory amp to turn on. I also have to get power to 3 so I'm guessing I have to splice this into number 4 as well but number 2 does not have any cables going to it from the ctsad003 harness so do I have to connect number 2 to number 4 as well?
That would be all 4 wires connected together. Is this correct?
Would any of the connections cause problems with the others? 1, 2 and 3 all seem to need an ignition power feed which 4 provides. I cant think of any other way it could be done.
Please help
Kane
I am posting this audio question on here because its a fairly urgent request and I know replies can take a while on the ICE section.
My Concert 2 stereo is knackered and basic. Only plays basic CDs and the volume control is knackered. I have a Sony GT710 stereo lying around with Ipod control so I'm going to install that (no going to look great but cheapest way for me to get good working audio).
This is a picture of the wiring:
1 is the amp remote wire from the headunit.
2 is the ignition switch from the headunit
3 is the power feed from the antenna
4 is the amp remote 12v switch from the connect 2 ctsad003 harness
Now I know that I need to connect 1 and 4 together to get the factory amp to turn on. I also have to get power to 3 so I'm guessing I have to splice this into number 4 as well but number 2 does not have any cables going to it from the ctsad003 harness so do I have to connect number 2 to number 4 as well?
That would be all 4 wires connected together. Is this correct?
Would any of the connections cause problems with the others? 1, 2 and 3 all seem to need an ignition power feed which 4 provides. I cant think of any other way it could be done.
Please help
Kane