- Joined
- Nov 11, 2009
- Messages
- 10,099
- Reaction score
- 739
- Points
- 38
- Location
- west yorks
- Website
- www.stainless-engineering.co.uk
Took my standard one off today and was quite shocked by the quality of it , a bit of hollow section and very thin fork (1.5mm) that goes on to the hub
am i correct in assuming these will want to be adjustable both ways from standard i.e shorter adjusting and longer adjusting? if it goes on the bottom tie bar it will want to be shorter and if replacing the top one it needs to be longer... around 40 mm of adjustment either way should be plenty..:icon_thumright:
am i correct in assuming these will want to be adjustable both ways from standard i.e shorter adjusting and longer adjusting? if it goes on the bottom tie bar it will want to be shorter and if replacing the top one it needs to be longer... around 40 mm of adjustment either way should be plenty..:icon_thumright: