OK, so we're getting to the point where it's looking to be all done. With the exception of WMI which, at the moment, I simply can't afford....lol.
Anyway, a few words on this TIP that's been fitted, and my experience thereof.
Fitment. It fits well, and to be fair, has moved the air filter further away from the engine than it was before which can only be a good thing... :thumbsup:
Performance. The outputs speak for themselves, and to be fair, it's even better out on the road.
Code:
Tuesday 2 November 2010 20:13:16
8L0 906 018 N 1.8L R4/5VT G 0002
Group A: 2 Group B: 11 Group C: 20
RPM Load Inj. On Time Mass Flow RPM Temperature Temperature Ign. Timing Idle Stabilization Idle Stabilization Idle Stabilization Idle Stabilization
TIME TIME TIME
Marker STAMP /min % ms g/s STAMP /min °C °C °BTDC STAMP CF CF CF CF
151.9 4040 177.4 10.66 153.31 152.31 5320 83 26 15 151.5 0 0 0 0
153.11 7480 187.2 15.17 264.14 153.51 7040 84 21 35.3 152.71 0 0 0 0.8
154.41 6040 191.7 17.63 254.06 154.81 6560 83 21 17.3 153.93 0 0 0 2.3
155.61 7400 188 15.17 265.83 156.01 7480 82 21 6 155.21 0 0 0 2.3
156.81 5520 191.7 18.45 245.67 157.21 5800 81 23 16.5 156.41 0 0.8 0 2.3
158.01 6280 191.7 18.04 258.81 158.41 6480 81 24 18.8 157.61 3 0.8 0 1.5
159.21 6840 191.7 16.81 264.14 159.7 7040 81 127.05 7040 158.81 3 0.8 0 0
169.8 4480 3 0 2.97 170.19 4400 81 29 9.8 170.59 0 0 0 0
211.18 2880 180.5 13.12 105.22 211.58 2960 83 26 12.8 212.08 0 0 0 3
212.48 3200 191.7 15.58 129.64 212.88 3320 83 24 12.8 213.37 0 3 3 5.3
213.87 3560 191.7 16.81 157.25 214.28 3720 83 24 14.3 214.78 3 2.3 2.3 5.3
215.28 4000 191.7 17.22 186.67 215.79 4120 84 24 15.8 216.17 2.3 2.3 2.3 4.5
216.58 4400 191.7 17.63 193.06 216.99 4480 84 24 15 217.39 2.3 1.5 2.3 3.8
217.77 4720 191.7 17.63 207.72 218.17 4840 84 25 13.5 218.57 2.3 1.5 1.5 3.8
218.97 5040 191.7 18.04 227.33 219.37 5120 85 27 14.3 219.77 2.3 1.5 1.5 3
220.17 5320 191.7 18.04 239.14 220.57 5240 85 27 2.3 220.97 0 0 0 0
221.37 4360 1.5 0 0 221.87 4320 85 25 9.8 222.28 0 0 0 0
222.76 4200 5.3 0 4.42 223.18 4120 85 27 9.8 223.66 0 0 0 0
The TIP has actually allowed more boost to be run for less timing pull. Under load, the timing is and always has been fine, but under normal driving conditions, such as motorway, the CFs were creeping up into the 6s so I knocked the timing back .75 degrees to drop that down.
Economy under normal day to day driving has gone up due to the slower spool time of the turbo. It's not permanently trying to boost it's little **** off. Again, this is deffo a good thing.
IATs are down on average. Under road use, I would normally see around 10 degrees above ambient temp. That has dropped to about 5-6 degrees on average.
As can be seen from the log files above, I am getting consistently 264/265 g/s air flow out on the road, I can't believe the difference in the driveability since TIP fitting. (mostly the torque).
All in all, a great bit of kit IMO, so thanks for letting me be a guinea pig Bill....
:thumbsup:
I'm a bit sad to see this project draw to a close