- Joined
- Mar 28, 2010
- Messages
- 10,073
- Reaction score
- 2,697
- Points
- 113
- Location
- Liverpool/Southport. N west
so this weekends job is hone, assemble rods and pistons, and install.
just this minute putting the pistons and rods together and i notice this:
as you can see, pin is all the way in, right up to the circlip.
the other side:
Not in far enough to put the other circlip in. Doh
my first thought was to a recent post of tufftys with 2 different 20mm pins, different lengths.
so im guessing mine are too long for my AGU pistons?? The seller probably found the same thing out
****.
what can i do now?
just this minute putting the pistons and rods together and i notice this:
as you can see, pin is all the way in, right up to the circlip.
the other side:
Not in far enough to put the other circlip in. Doh
my first thought was to a recent post of tufftys with 2 different 20mm pins, different lengths.
so im guessing mine are too long for my AGU pistons?? The seller probably found the same thing out
****.
what can i do now?