1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

I just want to cry

Speedy Steve Aug 20, 2010

  1. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    Have just come down to the south coast for a short holiday and made the huge mistake of going into a multi story car park (i know what was i thinking) Ive just Kerbed one of my shiny Ronal R50's. To say im in a foul mood is an understatement and not the best start to my break. Does anybody know anywhere that sell single alloys and may do these wheels as i dont fancy buying a hole new set?:(:(:(:(:(:(:(:(:banghead::banghead::banghead::banghead::banghead::banghead::sob::sob::sob::sob::sob::sob::sob::sob::sob::sob::sob::sob::sob:
     
  2. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
    Just get it refurbed matey! Don't worry about it!
     
  3. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    dont know if i can with it being diamond cut some of the bits are quite deep. WTF was i thinking
     
  4. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
    You can still get that refurbed no problem. It'll cost a bit more than your usual refurb as it's diamond cut but it's alot less than buying a new wheel! Enjoy your little holiday and sort the wheel when you're back. Like i say when something goes wrong .......... at least the car still works!! :)
     
  5. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    Just had an email from Rimstyle as i asked if they did single and i could have a new one at my door for 218 notes hum tempting
     
  6. voorhees

    voorhees Moderator Staff Member Moderator DSG

    16,081
    1,911
    113
    what !? you must have enough money to throw it away Steve as already said you can get it refurbed.
     
  7. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
    If you throw it away give it to me, i'll put a sheet of glass on top of it and make a nice coffee table© :laugh:

    But seriously, just get it refurbed you silly man :slap:
     
    Last edited: Aug 20, 2010
  8. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    ok who does good refurbs or do i go all out and get them all painted?
     
  9. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
  10. voorhees

    voorhees Moderator Staff Member Moderator DSG

    16,081
    1,911
    113
    I haven't had Diamond Cut wheels so am not in a position to answer that Steve,start another thread asking the question
     
  11. Broken Byzan

    Broken Byzan Photographic Moderator Staff Member Moderator VCDS Map User quattro Audi A4

    13,224
    464
    83
    Buy one, and stick the other into spare, SORTED.
     
  12. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    Tell you what i love the coffee table idea
     
  13. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
    Too bad, that's my idea so your wheel now belongs to me due to copyright! Read my post again about the coffee table :moa:
     
  14. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    Im torn between powder coating all 4 wheels or just buying a new one and by the time ive paid for powder coating im close to buying a new one so its a tough one
     
  15. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
    What colour would you want to powder coat though?
     
  16. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    i was thinking Satin black then have all the grey trim painted the same
     
  17. Nilz

    Nilz Defo worth the wait :) Team Ibis TFSI Owners Group quattro Audi A4 S-line owners group saloon Manual

    11,172
    810
    113
    Thought I would join in on this, dude, dont go satin black, it wouldnt do the wheels justice, they would end up looking like steelies!!

    Just diamond cut them again mate, will look spot on.

    Oh another idea for the spare if it comes to it, a hose reel for your hose pipe :)
     
  18. DJ_Troopa

    DJ_Troopa K1 Driver

    1,743
    14
    38
    LOL hose reel! Or you could cut the centre out and use it as a steering wheel. :racer:
     
  19. s3_kev

    s3_kev Stage2'd!!!!!!

    2,002
    23
    38
    either all referbed differently or buy a single wheel, they wont be able to match to original finish however good they are... where down south mate???
     
  20. Speedy Steve

    Speedy Steve Active Member

    1,258
    16
    38
    i was waiting to see how long it took you to see this Kev belive me i cryed when it happened and was in the foulest mood ever for several hours. Think im going to just get a new one the GF has give the all clear on the coffee table idea will be ordering it on monday just got to find the glass for the coffee table know and then sort the exhaust system just sits to low
     
  21. s3_kev

    s3_kev Stage2'd!!!!!!

    2,002
    23
    38
    gutted mate i love those rims too, belive me im in the foulest mood to when things like that happen to me i get proper agressive too.. found a little dent on my rear quarter the other day and a scratch on the rear bumper but im proper fecked off!! even though i pulled 90% the dent out and the bumpers need re-doing anyhow!!
     
  22. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    20,343
    3,494
    113
    Feeling your pain mate after the saga of my recent rain channel paint work... I feel violated :(

    <tuffty/>
     

Share This Page