1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  1. L7AUDI

    L7AUDI Member

    Messages:
    83
    Likes Received:
    2
    Trophy Points:
    6
    Is it possible to take say an S4 exhaust and fit to a 1.9tdi, not trying to make my car look like an S4 as it will always be an oil burner lol...just like the look, I know I'd also need the twin exit bumper to match :eyebrows:
     
  2. hades-

    hades- Yorkshire & Humber Rep. Regional Rep VCDS Map User

    Messages:
    9,468
    Likes Received:
    645
    Trophy Points:
    113
    just get the tips and have them welded on to yours
     
  3. VagCabby

    VagCabby Active Member

    Messages:
    488
    Likes Received:
    65
    Trophy Points:
    28
    As said, just cut the pointy down bits off your TDI exhaust and weld some tips on. I did it on the cheap, managed to get the tips for £15 for the two as they were slightly marked, then i cut my valance and painted it gloss grey, and this was the result, mines a 2.5 TDI

    [​IMG]
     
  4. L7AUDI

    L7AUDI Member

    Messages:
    83
    Likes Received:
    2
    Trophy Points:
    6
    yeah well of course I'd already thought of that! I was just testing everyone out :blink:
     
  5. Dan TheMan Welburn

    Dan TheMan Welburn Member

    Messages:
    460
    Likes Received:
    24
    Trophy Points:
    18
    I thought the same about this as id like a twin exit exhaust system on my 1.9tdi, all the mounting points are there so my plan is to fit the mounts from a car that has the twin exhaust standard, and then get a exhaust place local to me to do me a catback system
     

Share This Page