Any retrofitters in Newcastle?

[SAMZ]

Hey i'm looking for a audi retrofitter in Newcastle. Looking yo get some work done on my car. I own a 2007 b7 saloon and i'm looking to get done the following.

Fit a eagle eye led drl projector headlight unit and HID xenons, i currently have halogen headlights.

Upgrade tail lights to a led unit

LH/CH lights, i dont have auto lights or a auto dimming mirror.

Upgrade my steering wheel with a flot bottom S line one, i already have a 3 spoke MFSW one installed.

If anyone could point me in the right direction.
Thanks

 

[Sandra]

@jb0o

 

[SemedoB6]

I can do steering wheel..
Done on mine all coded and ready to go.
The lh/ch light depends on your central electric module. It might not support it..
8E0 907 279 this one is standard
8E0 907 279 F this one supports lh/ch lights.

Sent from my SM-G935F using Tapatalk

 

[SAMZ]

I can do steering wheel..
Done on mine all coded and ready to go.
The lh/ch light depends on your central electric module. It might not support it..
8E0 907 279 this one is standard
8E0 907 279 F this one supports lh/ch lights.

Sent from my SM-G935F using Tapatalk

Hmm how can i check mine? Is this the difference between highline and lowline for the module?

 

[SemedoB6]

Yes. Indeed..

If you have one of this:
8E0 907 279 A, 8E0 907 279 C or 8E0 907 279 D, you have the low line module.

If you have one of this:
8E0 907 279 B, 8E0 907 279 E or 8E0 907 279 F, you have the High line module.
Mine doesn't even have any letter in the end, so I assume mine is also a low line module...

From what I read the one ending in F is the one you want...
Ready Been looking they're going for about 40 quid on ebay. After that it'll be needed to be coded for it to work..
It should have a sensor so it would only work at night.. But without the sensor they will work during the day as well..

I will do it without the sensor as it is a nice feature even during the day..

Sent from my SM-G935F using Tapatalk

 

[SAMZ]

Thanks, guess i will try to open up the panel to have a look at what i got.

I hope its high line because i got a trip computer and bulb out warnings.

 

[SemedoB6]

Yeah.. Probably you have a highline module then..
If you do it just needs to be coded..
If your checking the module when you remove the trim under the steering wheel look straight up laying on the floor and you'll see the part number..

Sent from my SM-G935F using Tapatalk