Metal Fabrication In/near Birmingham

[DieselJake]

I've got some new seats but they don't line up so I was just looking if there was anyone/anywhere that could make some steel plates so I can line up the new under seat holes with the old.

Not sure on the general cost for this service but if it's expensive I can pick fitting runners for a few hundred quid just wanted to do it this way to cut costs.

 

[Arrkon]

I have generally used Chesman motorsport, in coventry, for most machining and fab work, including FMIC brackets and redrilling of a 1Z flywheel for a larger pressure plate. Cant really comment on other companies.

 

[DieselJake]

Cheers, might check them out tomorrow. I presume prices are competitive? Only had one place say they could do it so far and they wanted £130 per side haha the seats themselves cost less than that.