ok so iv managed to get hold a notebook so here goes to engine rebuild day 2
big thanks to mate richard for coming over last night to drop off an engine stand and engine crane.
and even bigger thanks to dwayne for coming over and helping to remove the motor.
so after removing dp and side shafts the motor was nearly ready to come out just had to take the mounts off
so while the motor was on the crane we decided to take some "omg im so strong" pics lol
cranks is bent to
there is ahole right thru the block lol!!! i did a good job
iv removed the head and so far found only 1 valve bent but not 100% sure as yet. the head is going into the engineering shop tomorrow anyway for new seals, guides and some flow work so they will go thru all the valves anyway
and after i loaded the head into a box and packed it with some foam i decided to put some degreaser and a brush to the box
just an update on the motor build.
my awesome mates at G-tec (lee) and Unitronic (yosh), has organized me a new set of AUM pistons, IE rods, new bearings, a nice clean block and a sump. they are going to be building it for me then once its ready ill be going to pick it up. they are really going out of their way for me so lots of beers and asian strippers need to get sent that way with love from me
big thanks to mate richard for coming over last night to drop off an engine stand and engine crane.
and even bigger thanks to dwayne for coming over and helping to remove the motor.
so after removing dp and side shafts the motor was nearly ready to come out just had to take the mounts off
so while the motor was on the crane we decided to take some "omg im so strong" pics lol
cranks is bent to
there is ahole right thru the block lol!!! i did a good job
iv removed the head and so far found only 1 valve bent but not 100% sure as yet. the head is going into the engineering shop tomorrow anyway for new seals, guides and some flow work so they will go thru all the valves anyway
and after i loaded the head into a box and packed it with some foam i decided to put some degreaser and a brush to the box
just an update on the motor build.
my awesome mates at G-tec (lee) and Unitronic (yosh), has organized me a new set of AUM pistons, IE rods, new bearings, a nice clean block and a sump. they are going to be building it for me then once its ready ill be going to pick it up. they are really going out of their way for me so lots of beers and asian strippers need to get sent that way with love from me