Today is a sad day......my S3 ownership has ended and my S3 is off to pastures new lol.
Very sad to see it go, however I’m pleased it will be given the attention it deserves.
Sent from my iPhone using Tapatalk
First off apologies for posting in this thread. I’ve removed my n/s shaft but, couldn’t for the life me loosen the 18mm ball joint nut so opted to remove the 3 nut/bolts holding the ball joint to the wishbone.
My dilemma now is I can’t get the wishbone anywhere near (sits way higher than the...
I have a non resonated system on mine with a decat and 3” pipewerx downpipe. It’s a lot quieter than you would expect unless giving it some. No drone at all.
A video of mine on cold start and a little rev at the very end.
Sent from my iPhone using Tapatalk
Sorry to revive an old thread but I’m having a very similar issue with my n/s rear caliper.
Car failed its MOT on a binding brake so I’ve taken it off the disc an free’d up the handbrake mechanism as I suspected this was the culprit.
My issue now is I cannot for the life of me wind the piston...
Well I never thought I’d be doing this but I’m putting the S3 up for sale. As much as I love it, I just don’t have the time to give it the attention it needs.
I will do a classified ad shortly.
Sent from my iPhone using Tapatalk
I thought they were discontinued myself? Best bet is eBay or the Facebook groups. Plenty on there (Facebook) breaking at the moment.
Not sure on the grille though
Sent from my iPhone using Tapatalk
Well today I decided to put the S3 back on the road as I felt sorry for it just sitting on the drive. I know I’ve wasted half a months tax but nevermind.....
Battery was completely dead so jumped her off my A4 and went to put some fuel in. I thought the 15 minutes between there an home would...
Hi mate, it will be fine sound wise as they’re not very loud at all even with downpipe and decat.
I’ll grab a video for you either tomorrow night or Saturday.
Sent from my iPhone using Tapatalk
Today I restored/polished the headlights on the S3.
Gave them a clean and quick clay before starting on the sanding.
I started off with 800 grit wet n dry.
I then worked my way up to 2500 grit, using 1200, 1500 & 2000 in between.
Next up I polished them using my Porter Cable 7424...
Yeah they’re very common to rust but, kind of expected at almost 17 year old unfortunately. I’ll be having mine done professionally too. I missed out on a mint drivers side wing the other week.
Gonna make a start on the headlights shortly.
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.