Intake duct suggestions

[finesse]

Just found out that my OEM Intake duct pipe
has split.

There are many threads on Forge and Samco...

Looking for suggestions for a replacement, my budget is not for a Forge.

Car
2001 AMK Revo stage 1

Options

1. Buy another OEM pipe

2. Buy this, anyone used this? Does a good job?
http://cgi.ebay.co.uk/AUDI-TT-SEAT-...FI&otn=10&po=&ps=63&clkid=8465607733862239286

3. Autobahn88
http://cgi.ebay.co.uk/Silicone-Indu...arts_Vehicles_CarParts_SM?hash=item335ac33d9c

 

[rossbrownlee]

try this linky

 

[kaizokuninja]

I would say that any of the Fleabay TIP's would be an upgrade from OEM, no?

 

[finesse]

http://cgi.ebay.co.uk/AUDI-TT-SEAT-...FI&otn=10&po=&ps=63&clkid=8465607733862239286


Thanks

 

[<tuffty/>]

I had the Autobahn88 TIP, fitted fine and worked well IMO...

<tuffty/>

 

[finesse]

I had the Autobahn88 TIP, fitted fine and worked well IMO...

<tuffty/>

Value your opinion tuffty! Will get that.

Where did you get the hose clips from

 

[<tuffty/>]

I used normal jubilee clips available from any motor factor etc but would advise using stainless ones if you can. I took the TIP in with me and just got the ones I needed so can't tell you what sizes you need off hand.

They don't need to be the hi-torque ones that Forge supply as its not under pressure on the inlet but I would use those if I were doing it again as you are less likely to get the 'click of death' when you tighten them.

<tuffty/>

 

[S3 Nattie]

Go for an Autobahn 88 one. They are very good quality and they are 4 ply thickness, same as a Forge or Samco hose. The fitment was really easy except for the DV hole, being very tight.

I had a slight gain when I installed mine. The turbo would die off about 500 rpm highier in the range and pull slightly smoother at the top of the range.

Dont be fooled by buying a Forge or Samc as your just paying for the name, this one if HALF the price (paid £51 I think).

You will need 6 jubilee clips. 50, 20, 20, 5, 30, 80mm roughly

 

[finesse]

Go for an Autobahn 88 one. They are very good quality and they are 4 ply thickness, same as a Forge or Samco hose. The fitment was really easy except for the DV hole, being very tight.

I had a slight gain when I installed mine. The turbo would die off about 500 rpm highier in the range and pull slightly smoother at the top of the range.

Dont be fooled by buying a Forge or Samc as your just paying for the name, this one if HALF the price (paid £51 I think).

You will need 6 jubilee clips. 50, 20, 20, 5, 30, 80mm roughly

Thanks :icon_thumright::icon_thumright: