Am I right in thinking, if I need to reset my TB, this is the process to follow?
- Disconnect both terminals on the battery
- Touch both the disconnected leads together for a few seconds
- Reconnect the battery
- Turn the key to the 'on' position .... no throttle ... no start ... for about a minute or two
If the TB reset works, I should here the servo step through the settings, right...?
- Disconnect both terminals on the battery
- Touch both the disconnected leads together for a few seconds
- Reconnect the battery
- Turn the key to the 'on' position .... no throttle ... no start ... for about a minute or two
If the TB reset works, I should here the servo step through the settings, right...?